‘From
the 1881 Household Cyclopedia’:
The soils most suited to the
culture of this plant are those of the deep, black, putrid vegetable
kind, that are low, and rather inclined to moisture, and those
of the deep mellow, loamy, or sandy descriptions. The quantity
of produce is generally much greater on the former than on the
latter; but it is said to be greatly inferior in quality. It
may, however, be grown with success on lands of a less rich
and fertile kind by proper care and attention in their culture
and preparation.
In order to render the grounds proper for the reception of the
crop, they should be reduced into a fine mellow state of mould,
and be perfectly cleared from weeds, by repeated ploughings.
When it succeeds grain crops, the work is mostly accomplished
by three ploughings, and as many harrowings: the first being
given immediately after the preceding crop is removed, the second
early in the spring, and the last, or seed earth, just before
the seed is to be put in.
In the last ploughing, well rotted manure, in the proportion
of fifteen or twenty, or good compost, in the quantity of twenty-five
or thirty-three horse-cart loads, should be turned into the
land; as without this it is seldom that good crops can be produced.
The surface of the ground being left perfectly flat, and as
free from furrows as possible; as by these means the moisture
is more effectually retained, and the growth of the plants more
fully promoted.
It is of much importance in the cultivation of hemp crops that
the seed be new, and of a good quality, which may in some measure
be known by its feeling heavy in the hand, and being of a bright
shining colour.
The proportion of seed that is most commonly employed, is from
two to three bushels [per acre], according to the quality of
the land; but, as the crops are greatly injured by the plants
standing too closely together, two bushels, or two bushels and
a half may be a more advantageous quantity.
As the hemp plant is extremely tender in its early growth, care
should be taken not to put the seed into the ground at so early
a period, as that it may be liable to be injured by the effects
of frost; nor to protract the sowing to so late a season as
that the quality of the produce may be effected.
The best season, on the drier
sorts of land in the southern districts, is as soon as possible
after the frosts are over in April; and, on the same descriptions
of soil, in the more northern ones, towards the close of the
same month or early in the ensuing one.
The most general method of putting crops of this sort into the
soil is the broadcast, the seed being dispersed over the surface
of the land in as even a manner as possible, and afterwards
covered in by means of a very light harrowing. In many cases,
however, especially when the crops are to stand for seed, the
drill method in rows, at small distances, might be had recourse
to with advantage; as, in this way, the early growth of the
plants would be more effectually promoted, and the land be kept
in a more clean and perfect state of mould, which are circumstances
of importance in such crops. In whatever method the seed is
put in, care must constantly be taken to keep the birds from
it for some time afterwards.
This sort of crop is frequently cultivated on the same piece
of ground for a great number of years, without any other kind
intervening; but, in such cases, manure must be applied with
almost every crop, in pretty large proportions, to prevent the
exhaustion that must otherwise take place. It may be sown after
most sorts of grain crops, especially where the land possesses
sufficient fertility, and is in a proper state of tillage.
Thick stands of fibre hemp compete well with weeds.
As hemp, from its tall growth and thick foliage, soon covers
the surface of the land, and prevents the rising of weeds, little
attention is necessary after the seed has been put into the
ground, especially where the broadcast method of sowing is practised;
but, when put in by the drill machine, a hoeing or two may be
had recourse to with advantage in the early growth of the crop.
In the culture of this plant,
it is particularly necessary that the same piece of land grows
both male and female, or what is sometimes denominated simple
hemp. The latter kind
contains the seed.
When the grain is ripe (which
is known by its becoming of a whitish-yellow colour, and a few
of the leaves beginning to drop from the stems); this happens
commonly about thirteen or fourteen weeks from the period of
its being sown, according as the season may be dry or wet (the
first sort being mostly ripe some weeks before the latter),
the next operation is that of taking it from the ground; which
is effected by pulling it up by the roots, in small parcels
at a time, by the hand, taking care to shake off the mould well
from them before the handfuls are laid down.
In some districts, the whole
crop is pulled together, without any distinction being made
between the different kinds of hemp; while, in others, it is
the practice to separate and pull them at different times, according
to their ripeness.
The latter is obviously the
better practice; as by pulling a large proportion of the crop
before it is in a proper state of maturity, the quantity of
produce must not only be considerably lessened, but its quality
greatly injured by being rendered less durable.
After being thus pulled, it is tied up in small parcels, or
what are sometimes termed baits.
Where crops of this kind are intended for seeding, they should
be suffered to stand till the seed becomes in a perfect state
of maturity, which is easily known by the appearance of it on
inspection.
The stems are then pulled
and bound up, as in the other case, the bundles being set up
in the same manner as grain, until the seed becomes so dry and
firm as to shed freely.
It is then either immediately
threshed out upon large cloths for the purpose in the field,
or taken home to have the operation afterwards performed.
The hemp, as soon as pulled, is tied up in small bundles, frequently
at both ends.
It is then conveyed to pits, or ponds of stagnant water, about
six or eight feet in depth, such as have a clayey soil being
in general preferred, and deposited in beds, according to their
size, and depth, the small bundles being laid both in a straight
direction and crosswise of each other, so as to bind perfectly
together; the whole, being loaded with timber, or other materials,
so as to keep the beds of hemp just below the surface of the
water.
It is not usual to water more than four or five times in the
same pit, until it has been filled with water. Where the ponds
are not sufficiently large to contain the whole of the produce
at once, it is the practice to pull the hemp only as it can
be admitted into them, it being thought disadvantageous to leave
the hemp upon the ground after being pulled.
It is left in these pits four,
five, or six days, or even more, according to the warmth of
the season and the judgment of the operator, on his examining
whether the hempy material readily separates from the reed or
stem; and then taken up and conveyed to a pasture field which
is clean and even, the bundles being loosened and spread out
thinly, stem by stem, turning it every second or third day,
especially in damp weather, to prevent its being injured by
worms or other insects.
It should remain in this situation
for two, three, four, or more weeks, according to circumstances,
and be then collected together when in a perfectly dry state,
tied up into large bundles, and placed in some secure building
until an opportunity is afforded for breaking it, in order to
separate the hemp.
By this means the process
of grassing is not only shortened, but the more expensive ones
of breaking, scutching, and bleaching the yarn, rendered less
violent and troublesome.
After the hemp has been removed from the field it is in a state
to be broken and swingled, operations that are mostly performed
by common labourers, by means of machinery for the purpose,
the produce being tied up in stones.
The refuse collected in the
latter process is denominated sheaves, and is in some districts
employed for the purposes of fuel. After having undergone these
different operations, it is ready for the purposes of the manufacturer.